A priming button (large beige washer) is included in the box with each set of elements. Be sure to keep this some place safe so that you can re-prime your element if needed.
To prime the elements, place the priming button on top of the threaded end of the element and place it firmly against your faucet. Turn the water on so that it is just a trickle. If you enjoyed this post and you would such as to get more facts pertaining to water treatment accessory buy kindly check out the page. The water will go into the black element and the outside of the element will slowly bead up and around the element. When it has completely beaded up the element you can turn off the water. Install the element into the Berkey water filter system.
We also have a new Berkey Primer for making this task even easier.
Be sure to throw out the first 2-3 batches of water you put through the system so that the tap water used for priming is completely out of the elements.
Alternate priming method is as follows:
STEP 1: If your system is assembled, remove the Black Berkey® Purification Element from the upper chamber. Next, fill the lower chamber with water, then place the Black Berkey Filters into the water in the lower chamber, water treatment accessory buy upside down with the stems facing upward, and put a ceramic coffee cup (or water treatment accessory something else that will hold them under the water) on top of each Black Berkey stem to force the element down under the water. Let the Black Berkey® Purification Element soak in the water for several hours. This will force some of the air out of the stubborn pores. NOTE: Make sure that the opening in the stems of the Black Berkey Filters are not underwater as we want the water to be forced through the pores rather than entering through the hole in the stem.
STEP 2: reverse osmosis RO membrane housing The inside of the Black Berkey® Purification Element should now be full of water filter element and significantly heavier. Try to keep as much water on the inside of the Black Berkey Filters as is possible as you reassemble the Black Berkey® Purification Element into the upper chamber by keeping the stems facing upward. Empty the water from the lower chamber. Place the upper chamber back onto the lower chamber. Immediately fill the upper chamber with water.
When the Black Berkey® Purification Element have water within the bore (inside core), more force is generated to draw water through the filters. This is because the water that drips out of the Black Berkey Filters also hydraulically pulls new water into the purification element as the Black Berkey® Purification Element begins to work like a siphon. Thus, in addition to the “Push” of gravity, there is also a hydraulic “pull” and this drastically improves the ability of the water to force the air from the micropores. The above method is less efficient than priming the Black Berkey Filters with the priming button but should be about 75-80% effective in clearing the blocked micropores. Let the water in the lower chamber run to waste. Refill the upper chamber with water. Your Black Berkey® Purification Element are now primed and ready for use.
